Skip to end of metadata
Go to start of metadata


Digium phones used without DPMA

Remote Restart

Digium phones, beginning with firmware 1.1.0, may be remotely notified to reconfigure by using a check-sync SIP NOTIFY Event sent from the Asterisk CLI. This feature is enabled by default and is controlled by the:

setting.

Older, as well as current, depending on the release, versions of Asterisk may not have a properly configured sip_notify.conf file to allow sending the reconfigure notices from the Asterisk CLI. To enable this functionality, add the following lines to pjsip_notify.conf:

; Digium

[digium-check-cfg]
Event=>check-sync

Following an Asterisk reload or restart, Digium phones may then be remotely sent reconfigure notices by executing the following Asterisk CLI command:

pjsip send notify digium-check-cfg <my endpoint identifier, e.g. 1000>
  • No labels