This option only applies if media_encryption is set to
It can be one of the following values:
no- meaning no verificaton is done.
fingerprint- meaning to verify the remote fingerprint.
certificate- meaning to verify the remote certificate.
yes- meaning to verify both the remote fingerprint and certificate.
Value used in Max-Forwards header for SIP requests.
The interval (in seconds) to send keepalives to active connection-oriented transports.
The interval (in seconds) to check for expired contacts.
Disable Multi Domain support
The maximum amount of time from startup that qualifies should be attempted on all contacts. If greater than the qualify_frequency for an aor, qualify_frequency will be used instead.
The number of seconds over which to accumulate unidentified requests.
The number of unidentified requests from a single IP to allow.
The interval at which unidentified requests are older than twice the unidentified_request_period are pruned.
Must be of type 'global' UNLESS the object name is 'global'.
Value used in User-Agent header for SIP requests and Server header for SIP responses.
When set, Asterisk will dynamically create and destroy a NoOp priority 1 extension for a given peer who registers or unregisters with us.
Endpoint to use when sending an outbound request to a URI without a specified endpoint.
The voicemail extension to send in the NOTIFY Message-Account header if not specified on endpoint or aor
Enable/Disable SIP debug logging. Valid options include yes, no, or a host address
The order by which endpoint identifiers are processed and checked. Identifier names are usually derived from and can be found in the endpoint identifier module itself (res_pjsip_endpoint_identifier_*). You can use the CLI command "pjsip show identifiers" to see the identifiers currently available.
When Asterisk generates an outgoing SIP request, the From header username will be set to this value if there is no better option (such as CallerID) to be used.
When Asterisk generates a challenge, the digest realm will be set to this value if there is no better option (such as auth/realm) to be used.
MWI taskprocessor high water alert trigger level.
MWI taskprocessor low water clear alert level.
Enable/Disable sending unsolicited MWI to all endpoints on startup.
Enable/Disable ignoring SIP URI user field options.
Place caller-id information into Contact header
Enable sending AMI ContactStatus event when a device refreshes its registration.
Trigger scope for taskprocessor overloads
Advertise support for RFC4488 REFER subscription suppression
This documentation was imported from Asterisk Version GIT-17-dda53007a56854